The signal controller for electric bicycles, electropeds - 5 in 1

The board was designed for signals on an electric bike. Power supply for 3 layer boards from 20 to 90 V 3A (you need a different current, write to me) Features of the 5 in 1: 1 signal controller - 2-channel turn controller - right and left turn signals. Maximum allowable current 1A (12 W) per side; 2,3 - stop-signal-dimension. The maximum allowable current is 1A (14 W). The brightness of the two modes "stop signal" and "dimension", the ignition time - you can adjust the buttons. It works ideally if there are brake handles with a circuit breaker that would work not only the size, but also the brake light when braking - opto-isolation with the controller and the handle. 4 - smooth inclusion of a headlight. The maximum allowable current is 3A (36 W). When turned on, the headlight turns on smoothly with or without delay. All of these parameters are adjustable. 5 - DRL, daytime running light, with reduced fury, the parameters are adjusted by buttons. The block size is 95 mm long, 47 mm high, 30 mm. Power is 20-90 V. The power is connected to the volt board, and then the board is already parted for turns, stop and headlight. * Options - instructions, controller in the case. * If you need to solder wires, control knob, ask!