BMS BMS 14S with monitoring with unlimited current output and charge up to 30A

BMS BMS 14S with monitoring with unlimited current output and a charge of up to 30A A feature of this development is the absence of such a parameter as the load current: the device controls only the low-current part, turning off the power of the “low-current”, and the power line is connected directly to the consumer (motor controller) through the circuit breaker and / or fuse. Thus, fault tolerance is increased, losses are reduced, and the absence of "extra" keys also favorably affects the cost. The device comes with programmed microcontrollers on the "standard" thresholds for Lithium-Ion (Polymer) and Lithium-Iron-Phosphate batteries (two algorithms are wired, but one is activated). There is also the possibility of setting "other" thresholds of protection and balancing at the request of the customer. Technical characteristics: - overall dimensions (LxWxH): 135x58 * 7.5 (for 24S) - number of channels served: 7-24 on one board. The possibility of "stacking" to expand the number of channels. Connecting a "non-standard" channel channels without interfering with the construct (just do not activate the "extra" ones, but no more than 70% of the number of soldered ones) - maximum charging current: 15A (you can supply more if you can control the heating) - maximum load current " low-current ": constant 1.5A, short-term (up to 10sec) up to 6A (the controller consumes about 0.06A) - balancing current: ~ 50mA for Li-Po (Li-Ion) / ~ 44mA for LiFePO4